Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects four SATA drives to a Mini SAS HD SFF-8643 controller at 6 Gb/s over a 100 cm cable
This cable links a single Mini SAS HD SFF-8643 host connector to four SATA 7-pin device connectors. It lets servers or RAID controllers attach up to four SATA hard disks through one high-density port. The one-metre length suits typical internal chassis routing. Builders needing more than four drives per controller cannot use this cable.
The assembly meets the SAS 2.1 specification for 6 Gb/s data rates and uses the HD Mini-SAS connector family that will carry forward to SAS 3.0. Shielded copper conductors keep crosstalk low inside a crowded drive bay. No active electronics are present, so the link draws no extra power and adds no audible noise. Thermal load is limited to passive conductor resistance.
The 1-to-4 breakout replaces four separate cables, reducing clutter and connection points in a RAID enclosure. Straight SATA 7-pin plugs fit standard drive backplanes directly. No driver, firmware or configuration utility is bundled; the cable is transparent to the operating system. Users requiring right-angle SATA plugs or locking latches must source a different cable.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Chenyang |
| Product type | Mini-SAS |
| Product color | Black SFF-8643 to 4SATA 100 cm |
| Performance | |
| Rated speed | 6 Gbit/s |
| Ports & slots | |
| Connector count | 112 |
| Connector details | Sff-8643 |
| Connector gender | Male-to-Female |
| Size & build | |
| Cable shielding | 1-to-4 |
The SFF-8643 connector is keyed; align the notch with the controller port before pressing it in. The four SATA 7-pin plugs then attach to each drive with a straight push until the latch clicks.
The SATA 7-pin latch clips can fatigue after repeated drive swaps; if a clip no longer holds, replace the whole 1-to-4 assembly.
The cable is rated for 6 Gb/s per lane, so sustained transfers will hit that ceiling before the copper length becomes a factor.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?