Vszerda Molex 4 Pin Power Extension Cable 14 Inch 18AWG
Extends a Molex 4-pin power connection by 14 inches using 18AWG tinned copper wire rated for 12V and 5V DC
- Extends Molex power reach by 14 inches
- 18AWG tinned copper conductors carry 12V and 5V reliably
- UL1007 rated wire meets safety standards
- Male to female LP4 connectors fit existing PSU cables
- Multi-colour wires simplify polarity identification
Purpose & compatibility
This Molex 4-pin extension cable adds 14 inches of reach between a power supply and drives or fans that use the standard LP4 connector. It suits builders who need extra length in a full-tower chassis or when routing behind a motherboard tray.
Thermals, noise & power
The 18AWG tinned copper conductors carry 12V and 5V DC without adding measurable resistance, so voltage drop stays negligible under normal loads. The cable itself produces no noise and generates no heat beyond what the attached devices already draw.
Bundled accessories & software
No software, adapters or mounting hardware are included; the package contains only the male-to-female extension. The UL1007-rated insulation ensures the wire meets basic safety standards for internal wiring, but no additional certifications or cable ties are supplied.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $5.99
- Cheaper than about 94% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How do I connect the 14 inch 18AWG extension between the PSU Molex plug and my device?
Plug the LP4 male end into the PSU Molex connector and the female end into the drive or fan; the keyed shape prevents reversed insertion, which is the common error.
Will the 18AWG tinned copper conductors or UL1007 insulation need replacement over time?
The 18AWG tinned copper and UL1007 insulation are rated for the 5V and 12V DC supply; replacement is only needed if the jacket is cut or a pin is bent.
At what point does voltage drop become noticeable on the 14 inch 18AWG run under constant load?
The 14 inch length and 18AWG gauge keep resistance low, so voltage drop stays minimal for typical 5V and 12V DC loads on Molex devices.
More in Internal PSU & Riser Cables
Similar items
STARTECH TX3SPLITTER 6.1 in TX3 Fan Power Splitter Cable
- 0.5 ft (0.15 m)
- Cable Connectors
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Micro Connectors 6-Pin PCIe to Dual 15-Pin SATA Power Cable
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





