Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Active OCuLink cable bridges SFF-8611 and SFF-8643 connectors at up to 8 Gbps over 50 cm
This 50 cm active cable bridges an OCuLink SFF-8611 4i controller to a backplane or enclosure with an SFF-8643 connector. It targets builders adding external GPU or SSD links where a native OCuLink port is available. The cable is not compatible with SFF-8643 slimline SAS RAID cards.
The active latch secures each end without thumb screws, so installation is a simple push until it clicks. Route the 50 cm length carefully; sharp bends near the connector housings can stress the active circuitry and cause link errors. A free OCuLink interface on the host side is the only system requirement.
Each of the four lanes runs at up to 8 Gbps under PCIe 4.0, giving aggregate bandwidth suited to modern GPUs and high-speed SSDs. The 64 Gbps shielding rating provides headroom for signal integrity at full speed. Runs longer than 50 cm or passive alternatives would be needed for greater reach.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | NGFF |
| Product type | Oculink |
| Product color | Black |
| Size & build | |
| Cable shielding | High Speed 64 Gbit/s |
Verify the active latch clicks securely into both connectors and check that the host system detects the attached drives or eGPU at the expected PCIe 4.0 link speed.
The box includes the 50 cm active cable with SFF-8611 4i and SFF-8643 male ends; you must supply a controller with a free OCuLink SFF-8611 port and a backplane or device with an SFF-8643 connector.
Select this SFF-8611 4i to SFF-8643 active cable; it is built for PCIe 4.0 links up to 64 Gbps and will not work with SFF-8643 SAS RAID cards.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?