Tripp Lite U026-016 USB 2.0 Active Extension Cable 16 ft
- USB A to USB A
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Extends a motherboard USB 3.0 19/20-pin header by 15 cm with a flexible flat ribbon to clear graphics-card clearance issues
This 15 cm flat-ribbon cable connects a motherboard USB 3.0 19/20 pin header to a front-panel or accessory connector when the original header is blocked by a graphics card. It is built for PC builders who need to relocate the internal USB 3.0 link in a tight chassis. The male-to-female layout plugs straight into the existing header without adapters.
The passive cable draws no power and adds no audible noise to the system. Its shielded flat-ribbon construction helps maintain signal integrity while allowing tight bends that improve airflow around the graphics card. Heat dissipation relies on the PVC jacket and the open routing space created by the extension.
The connector fits only motherboards that expose a standard 19/20 pin low-profile USB 3.0 header; some boards use a different pinout and will not accept this cable. Verify the header layout in your motherboard manual before purchase.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | YARCHONN |
| Product type | USB |
| Ports & slots | |
| Connection type | Usb 3.0 19pin 20 Pin |
| Connector details | Usb 3.0 19pin 20 Pin |
| Connector gender | Male-to-Female |
Route the 15 cm flat ribbon cable around the graphics card, align the 19-pin or 20-pin keyed connector with the motherboard header, press the male end fully into the board, then attach the front-panel USB 3.0 cable to the female end; the keyed notch prevents reverse insertion, which is the step most builders miss.
The shielded flat ribbon is designed for a single internal installation; no periodic maintenance is required, but if the cable is repeatedly bent sharply or the connector latch fatigues, replace the entire 19/20 pin extension to restore reliable 5 Gbps signal integrity.
The 15 cm length keeps signal loss minimal, so the 5 Gbps USB 3.0 specification ceiling is reached before any cable-induced degradation; thermal throttling does not occur because the PVC jacket dissipates heat from the low-current header lines.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?