Tripp Lite U026-016 USB 2.0 Active Extension Cable 16 ft
- USB A to USB A
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
An 18 cm USB 3.0 19-pin male-to-female extension cable routes the front-panel header outward for easier case assembly
This 18 cm cable extends a motherboard 19-pin USB 3.0 header to the front panel. It connects a 19-pin male plug to a 19-pin female socket so the interface faces outward. The link supports 5 Gbps transfer rates and remains backward compatible with USB 3.0 and 1.1 devices. Builders use it when the stock header cable cannot reach the chassis front ports.
Three layers of shielding wrap the conductors to reduce signal interference during high-speed transfers. The full-duplex design carries four differential pairs for simultaneous bi-directional data flow. The outward-facing female connector snaps onto the motherboard header in one direction only, so the installer must verify orientation before seating it. No additional drivers are required on supported Windows versions.
The cable upgrades cases where the original front-panel header cable is too short or absent. It is worth the jump when the motherboard header sits far from the front I/O cutout and a longer internal run is needed. Buyers who need an inward-facing connector or a different pin-count header cannot use this model.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The cable is rated for 5Gbps and is backward compatible with USB 3.0 and 1.1 devices.
The 19-pin male end plugs into the motherboard header and the female end faces outward, so allow space for the cable to bend away from the board.
Align the 19-pin male connector with the motherboard header, noting the outward-facing direction, and press firmly until the latch clicks.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?