Athena Power AP-P4ATX60FE 600W server power supply
- 600 W
- Single
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Delivers 500 W continuous and up to 600 W peak from a 1U rack-mount chassis with 24-pin, dual 8-pin, SATA and custom 10-pin connectors
The WMtec DPS-500YB is a 500 W rack-mounted 1U server power supply built for compact enterprise chassis. It delivers 24-pin, dual 8-pin, two SATA and one custom 10-pin connector that breaks out to a large 4-pin and additional SATA. The unit suits administrators fitting dense 1U racks with standard ATX-derived cabling.
Rated output holds at 500 W during continuous operation while short-term peaks can reach 600 W under test conditions. The 1U form factor keeps airflow aligned with server ducting so thermal load stays predictable during extended compute runs. Steady voltage regulation supports constant disk-array and CPU workloads without throttle cycles.
This supply fits slots where an existing 500 W 1U module has degraded or where a lower-wattage unit cannot drive added drives and expansion cards. The custom 10-pin breakout covers proprietary backplane pins that generic ATX units lack. Buyers needing redundant hot-swap frames or higher continuous wattage should verify chassis compatibility before purchase.
Measured against everything we stock in Server & Hot-Plug PSUs, at today’s prices. Recalculated every night.
New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The unit is a rack-mounted 1U server power supply rated at 500W with a peak test of 600 watts; its internal fan speed scales with load and temperature inside the chassis.
It uses a 24-pin main connector, two 8-pin CPU connectors, two SATA connectors and a custom 10-pin interface that converts to a large 4-pin and extra SATA.
Yes, the supply provides two standard SATA power connectors alongside the custom 10-pin breakout, so existing SATA drives can be powered directly.
More in Server & Hot-Plug PSUs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?