Tripp Lite U026-016 USB 2.0 Active Extension Cable 16 ft
- USB A to USB A
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a 4.0 mm banana-plug charger to eight common RC battery connectors using flexible silicone-insulated leads
This cable consolidates eight common RC battery connectors into a single splitter, letting hobbyists charge TRX, Tamiya, Tamiya mini, EC3, JST, Futaba, XT60 and T-Plug packs from one charger. It replaces a tangle of individual leads and suits anyone who runs multiple connector types on the bench or at the field. Builders who need more than eight simultaneous outputs or proprietary connectors not listed will need additional adapters.
The leads use flexible silicone wire rated for high temperature and flame retardant operation, so the cable stays pliable during charge cycles without melting or stiffening. Gold-plated contacts on the 4.0 mm banana plugs and each output keep resistance low and reduce heating under typical charge currents. No active cooling or fan noise is involved because the assembly is entirely passive.
One octopus lead substitutes up to eight dedicated charge cables, cutting clutter and cost for pilots who swap between connector standards. The upgrade is worthwhile when a charger only offers banana-plug outputs but the fleet uses TRX, EC3, XT60 and the other listed types; it is not a solution for chargers that require proprietary balance ports or communication protocols.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Ports & slots | |
|---|---|
| Connection type | Convert Cable |
Plug the 4.0 mm banana plugs into the charger’s output sockets, matching red to positive and black to negative, then select the single output lead that matches your battery — TRX, Tamiya, Tamiya mini, EC3, JST, Futaba female, XT60 or T-Plug — and leave the other seven leads unconnected.
The silicone insulation resists high temperature and flame, and the gold-plated contacts resist corrosion, so under normal hobby use neither the leads nor the contacts require scheduled replacement; inspect for physical damage after crashes or overheating.
The cable’s 4.0 mm banana plugs and the assortment of output connectors set the practical continuous-current limit; sustained loads above the lowest-rated connector in the chain will cause heating at that joint first.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?