Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Quiet 40-pin cooling fan with programmable RGB and OLED display for Raspberry Pi temperature control
The Yahboom cooling fan attaches directly to the 40‑pin GPIO header on Raspberry Pi 4B, 3B+ and 3B boards. It targets hobbyists and educators who want active temperature management without soldering or extra wiring. The unit also breaks out the header so other HATs or sensors can still be connected.
Three high‑brightness RGB LEDs sit on the expansion board and can be coded to show different colours for different temperature ranges. An OLED module may be included as a random gift. The fan speed is adjusted in software based on the board temperature, and the driver package works with all standard Raspberry Pi OS images.
This kit upgrades builds that rely on bare heatsinks or constant‑speed fans by adding temperature‑controlled, programmable cooling. The jump is worth it when you need quieter operation, visual temperature feedback and the ability to keep the GPIO header free for other peripherals. Not for users who only need a simple plug‑and‑spin fan without writing or running any code.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Processor | |
|---|---|
| Processor | Other |
The fan connects directly to the 40-pin header with no wiring or wasted I/O ports, and the board also expands the header so other devices can still be attached.
It sits on the 40-pin GPIO header as a HAT, adding a fan and RGB OLED module above the board while leaving the I/O port layout unaffected.
You must run the Yahboom-provided program after powering on; until that script runs the RGB lights illuminate but the fan stays stationary.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?