BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Dual-hotend bracket holds two 3010 TurboFans and one hydraulic fan, runs on 12 or 24 V and includes a 3.3 ft extension cable
This 3D printer accessory mounts two 3010 TurboFans and one 3010 hydraulic fan onto a single bracket with four mounting holes for height adjustment. The compact, lightweight design improves heat dissipation at the hotend. It is intended for printers that use a 1-in-2-out dual hotend configuration.
The included fans operate on either 12 V or 24 V supply, matching common printer voltages. A 3.3 ft extension cable is provided for flexible routing to the control board. The bracket is only compatible with the specific dual hotend layout described by the supplier; other hotends require manual verification of mounting dimensions.
Upgrading from a single blower adds dedicated airflow to each nozzle without increasing the hotend footprint. The jump is worth it when printing with materials that demand rapid layer cooling or when the stock fan cannot maintain stable temperatures across both outlets. Builders needing a different hotend geometry or more than two outlets should look elsewhere.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Select the 12V or 24V package that matches your printer’s fan voltage; the listing includes two 3010 TurboFans and one 3010 hydraulic fan.
The twin 3010 TurboFans push air through the integrated duct for focused part cooling on a single-output dual hotend.
The fans only run at their rated 12V or 24V; wire them to the matching voltage rail on your printer’s control board.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?