BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Stepper motor with 40-tooth brass gear drives extrusion on compatible 3D printers
The YINGHUA 42-40 stepper motor integrates a 40-tooth brass extrusion gear for direct-drive extrusion on compatible 3D printers. It operates with a 1.8-degree step angle, 1.5A current rating and a rated torque of 0.4NM across a 1-1000rpm speed range. The metal construction supports stable, low-noise operation without lost steps during printing.
This motor fits Ender-3, Ender-3 Pro, Ender-5 and multiple CR-series models including CR-10, CR-5 and CR-3040 variants. Builders using other printer architectures or requiring a different gear ratio should verify compatibility before purchasing. The fixed 40-tooth brass gear cannot be swapped for alternative tooth counts.
The motor delivers a 1.8-degree step angle with a holding torque of 0.4NM at 1.5A and 4.83V. This specification determines whether the extruder can maintain precise filament control at your chosen print speeds. Confirm that your printer's driver and firmware settings match these electrical and mechanical parameters.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Rotate the motor shaft by hand; it should move in distinct 1.8 degree increments. Under power, the motor should run smoothly at 1-1000 rpm with no missed steps and maintain the 0.4 Nm torque rating.
The box contains one complete stepper motor set with the 40-tooth brass extrusion gear pre-installed. No separate mounting bracket, wiring harness or driver board is included.
The single 42-40 model with 1.5 A current rating and 4.83 V nominal voltage fits all listed printers including Ender-3, Ender-3 Pro, Ender-5, CR-10 and CR-10S.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?