BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 30 cm printhead cable compatible with Epson R1390, L1800, 1400, 1410, 1430 and 1500 printers
This 30 cm printhead cable is a new compatible replacement designed for Epson R1390, L1800, 1400, 1410, 1430 and 1500 printers. It restores the electrical connection between the carriage board and the printhead when the original ribbon cable has failed or been damaged during maintenance. One piece is supplied.
The cable carries all signal and power lines required for sustained printing sessions on the listed models. Its 30 cm length matches the original routing so the carriage can travel its full stroke without tension or snagging. No active components are present; reliability depends on secure seating at both connectors and on keeping the ribbon free from ink contamination.
Confirm that your printer is one of the six models named above, as connector pin-outs differ across other Epson series. Inspect the existing cable for cracked conductors or corroded contacts to verify that the ribbon itself is the fault. Ensure the carriage path and cable guide are clear of debris so the new ribbon lays flat during operation.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The cable is a passive ribbon assembly with no active electronics, so it produces no heat or audible noise regardless of how long the printer runs.
The cable mates with the standard FFC printhead socket found on the R1390, L1800, 1400, 1410, 1430 and 1500 models; no adapter or additional board is required.
Yes, the replacement is pin-compatible with the factory cable used on the 1400, 1410, 1430, 1500, R1390 and L1800, so the existing carriage board works unchanged.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?