BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Set of four TMC2130 stepper motor drivers with heatsinks for silent 3D printer operation at 1.2 A continuous current
This pack contains four TMC2130 stepper motor driver modules, each fitted with a heatsink. They are designed for two-phase stepper motors running at 12 V or 24 V DC with a continuous current of 1.2 A and a peak of 2 A. The standard SPI interface connects directly to SKR 2 or SKR boards after the jumper cap is set. Makers upgrading a printer’s motion control will find the 256 microstep resolution useful.
The drivers reduce motor noise to below 10 dB at low velocities, keeping operation quiet during long prints. A large-area cooling surface on each module dissipates heat efficiently, so temperatures stay low even when the motors run for hours. Steady torque is maintained without the whine common in traditional current controllers.
These modules replace older driver boards that lack SPI control or 256 microstep capability. The upgrade is worth it when print quality suffers from audible motor vibration or when the controller board supports SPI but the original drivers do not. They are not suited for systems that require higher current than 2 A peak or voltages outside the 12 V to 24 V range.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Motor noise is below 10 dB at low speeds, so operation stays near-silent even during long prints.
A board with native SPI support such as an SKR 2 or SKR series lets you connect the jumper cap and drive the modules directly.
Yes, each module accepts 12 V or 24 V DC input, matching the voltage of most common printer power supplies.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?