BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
High-power TMC5160 stepper driver with external MOSFETs handles up to 20 A for precise 256-microstep control on 42-size motors
The YINGHUA TMC5160 V1.3 42 stepper motor driver delivers high-current control for 3D printer upgrades. It targets makers who need reliable motion performance on boards such as the BTT Octopus SKR V1.4 or SKR Mini E3. The module fits enthusiasts and professionals seeking precise motor management for complex prints.
An externally expanded power MOS tube supports current up to 20A while keeping heat output low. The small footprint of approximately 15.3 by 20.4 millimetres allows installation in tight electronics cases. Standard pin spacing matches common controller headers for straightforward mounting.
This unit upgrades from lower-current drivers such as the TMC2209 when motors demand more power. The jump is worthwhile for heavy gantries or high-torque extruders that exceed standard driver limits. Firmware support through Marlin 2.0 with 256 microstepping ensures smooth motion without additional configuration complexity.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The driver uses a standard SPI interface to communicate with boards such as the BTT Octopus SKR V1.4, enabling Marlin 2.0 firmware support.
The board measures approximately 15.3 by 20.4 millimetres and follows the common 42 mm stepper driver footprint for direct plug-in installation.
Align the pins with the socket, press firmly until seated, and ensure the jumper configuration matches UART or SPI mode; the frequent error is inserting the module backwards or offset by one row.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?