BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Ten precisely cut 254 mm polyimide sheets withstand 280 °C and give reliable bed adhesion for ABS, PLA and other thermoplastics
This pack supplies ten precisely die-cut Kapton polyimide sheets measuring 254 by 254 mm. Each sheet is 0.06 mm thick with a silicone adhesive layer and a release liner for clean handling. The material withstands temperatures up to 280 °C. It is intended for 3D printer build surfaces.
Makers printing ABS, PLA, PVA or polycarbonate gain reliable first-layer adhesion. The release liner simplifies bubble-free application on glass beds. Users requiring continuous rolls or widths other than 10 inches should look elsewhere. The pack contains only ten individual squares.
The 280 °C (536 °F) rating determines whether the tape survives the bed temperatures demanded by materials such as polycarbonate. Lower-rated sheets may degrade or lift during long prints. Verify your printer's maximum bed temperature against this limit before purchasing.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
This listing supplies ten 10x10in sheets, each 0.06mm thick with a release liner, giving you multiple fresh build surfaces for repeated prints.
The polyimide film and silicone adhesive withstand continuous bed temperatures up to 280°C, so ABS, PLA, polycarbonate and other thermoplastics stay adhered without the tape degrading.
The 0.03mm silicone adhesive layer bonds firmly to glass at printing temperatures up to 280°C and releases cleanly with the included liner, especially when applied with a Windex layer to remove bubbles.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?