BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
GT2 timing belt and 20-tooth aluminium pulley kit for 3D printer motion systems
This set supplies one GT2 timing belt and one 20-tooth GT2 timing pulley for 3D printer motion systems. The belt uses neoprene reinforced with fiberglass and the pulley is machined from aluminum. Both components share a 2 mm pitch and 6 mm belt width for direct compatibility. The kit is intended for builders upgrading or repairing linear-drive mechanisms.
The fiberglass reinforcement inside the neoprene belt resists stretch over long print runs, keeping tooth engagement consistent. Aluminum pulley teeth maintain their profile without the wear seen on plastic alternatives. Two M4 set screws lock the 5 mm bore to a motor shaft, preventing slippage during repeated acceleration cycles. The 582-groove belt length supports extended axis travel without joining sections.
The 2 mm pitch and 6 mm width define the maximum torque the pair can transmit without skipping. A 5 mm bore diameter restricts the set to stepper shafts of that exact size. The 1164 mm pitch length fixes the centre-to-centre distance achievable in a given frame. Builders needing a different bore, width or longer belt must source separate components.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The neoprene belt and aluminium pulley are passive mechanical parts; they produce no heat and only the normal meshing sound of a 2 mm pitch GT2 drive.
You need a stepper or idler shaft of 5 mm diameter, a 2 mm hex key for the two M4 set screws, and a printer frame that accepts a 1164 mm pitch-length belt.
Yes, any system designed for 2 mm pitch GT2 profile and 6 mm belt width will mesh correctly with the 582-groove belt and 20-tooth pulley.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?