Shenzhen Aimilai Technology Co.Ltd. M.2 NVMe to PCIe x4 Adapter with Heatsink Gold Aluminum Black
- Gold
- Aluminum, Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pre-bent 90-degree Plexi hard tubes for custom water-cooling loops, 13mm outer diameter and 10mm inner diameter, supplied as ten 30cm lengths
Alphacool 18565 HardTube is a pre-bent plexiglass tube designed for custom water-cooling builds. It suits enthusiasts who want rigid, structured tubing runs without cutting and bending straight stock themselves. The 90-degree angle simplifies tight corner routing inside the case.
The tube carries coolant passively and adds no heat, noise or power draw to the system. Flow resistance depends on the overall loop layout rather than the tube alone. Properly installed joints remain leak-free during normal operation.
Each piece measures 30cm in length with a 13mm outer diameter and 10mm inner diameter. The pack contains ten pre-bent sections ready for cutting to final size. Connections require careful alignment; Monsoon-brand fittings are not compatible.
Measured against everything we stock in RAM & Chipset Heatsinks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Alphacool |
| Model name | 1014199 |
Cut each 30 cm tube to exact length, deburr the ends, then push straight into 13/10 mm fittings; the maker notes that angled insertion is the step that causes leaks.
Inspect for stress cracks or clouding after long UV or heat exposure; replace any tube that shows whitening or micro-fractures because PMMA cannot be repaired.
PMMA softens above its glass-transition temperature, so prolonged high coolant temperatures will deform the 90° bends before fittings or seals fail.
More in RAM & Chipset Heatsinks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?