Shenzhen Aimilai Technology Co.Ltd. M.2 NVMe to PCIe x4 Adapter with Heatsink Gold Aluminum Black
- Gold
- Aluminum, Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Stick-on heatsinks for memory modules, chipset chips and small boards, plus compact fan-and-heatsink coolers for older bridge chips. 86 products from $1.11 to $561.99. Unique-Bargains, Alphacool, GELID SOLUTIONS and more.
86 products from $1.11
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
86 results · page 1 of 2
Plain DDR3 and DDR4 sticks at stock speed run cool, so a heatsink there is optional. Kits pushed to higher speeds and voltages, and DDR5 modules that carry their own power circuitry, shed more heat and gain from a spreader. Check what you already own first: many gaming kits arrive with spreaders glued on, and stacking a second set only traps heat. Listings that claim to fit DDR through DDR5 are generic adhesive or clip-on sets, so measure your module rather than trusting the label.
Material matters less than contact. Aluminum is light and cheap, while copper conducts heat better but weighs more and can peel a thermal pad off a tall module. Always check height: a spreader that adds a few millimeters can collide with a large tower CPU cooler sitting over the first memory slot.
Small chipset chips, the north and south bridges on older boards, and single-board computers usually take a passive kit of tiny aluminum or copper blocks that stick on with thermal tape. Check the block footprint against the chip, because a block wider than the chip leaves it hanging off the edge. Where airflow is poor, a fan-and-heatsink unit helps, but look at the power plug first: a 3-pin or 4-pin fan header must exist near the spot you plan to mount it.
For noise, compare the rated speed and decibel figure in the listing. A fan spinning at 3,000 RPM or more is audible in a quiet room, while a slower one on a variable-speed header is much calmer. Remember that a fan only moves air over the block, so it helps most when the case has some airflow to carry the warmth out, and a bare heatsink with good airflow can be the quieter, longer-lived choice.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?