CableCreation Mini SAS SFF-8643 to 4x SATA 90-degree cable 0.5m 1.6ft
Connects a Mini SAS SFF-8643 host port to four SATA drives with 90-degree connectors for tight spaces, 0.5 m length
- Connect RAID controllers to four drives via SFF-8643 host port
- 90-degree SATA plugs ease routing in tight chassis spaces
- Supports 12 Gb/s SAS throughput for high-speed storage arrays
- 5 m length keeps signal paths short inside the case
- Hybrid SFF-8643 design enables smooth 6 Gb/s to 12 Gb/s transition
Mini SAS SFF-8643 breakout cable
This CableCreation cable splits a single Mini SAS SFF-8643 host port into four SATA connectors. It is intended for builders connecting up to four hard drives or SSDs to a motherboard or RAID controller that uses the SFF-8643 interface. The 0.5 m length suits compact chassis where a short run keeps airflow tidy. It will not work if the SFF-8643 port sits on a backplane rather than the host side.
90-degree SATA plugs for tight routing
Each SATA connector uses a 90-degree angle so the cable can hug the drive cage or motherboard tray. This reduces the bend radius needed behind stacked drives and helps prevent accidental disconnection during maintenance. The Mini SAS end plugs straight into the host port without an angled hood. Signal integrity follows the SAS 12 Gb/s specification so sustained throughput matches the controller and drive limits.
Host-side only compatibility check required
Installation is a simple push-fit on both ends, but the critical step is verifying the SFF-8643 port belongs to the host or RAID card. If the same connector appears on a backplane or expander, the pin-out is reversed and the cable will not function. No drivers or configuration are needed once the correct host port is confirmed. The short 1.6 ft length leaves little slack, so measure the routing path before ordering.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $14.99
- Pricier than about 55% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Does the 90-degree SATA connector reduce heat or power draw when the drives run continuously?
The 90-degree design only improves cable routing in tight spaces; it does not change heat output or power consumption of the attached drives.
What host interface must my motherboard or RAID controller provide for this cable to function?
The host side requires a Mini SAS SFF-8643 port; the cable will not work if that connector is on a backplane instead.
Will this SFF-8643 to 4x SATA cable work with older 6 Gb/s SATA hard drives I already own?
Yes, the cable carries SAS signals that are backward-compatible with 6 Gb/s SATA drives connected to the four 7-pin SATA plugs.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATAPOWADPL 6 in 4 pin Molex to left angle SATA power adapter cable
- 6 in (15.2 cm)
- Cable Connectors
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
BENFEI 000306black-6p SATA cable 6 pack 18 inch 90 degree locking latch black
- Male-to-Male
- SATA III
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
Cable Matters 104008-24x3 3-Pack 90° SATA Cable 24in Red
- Sata
- SATA





