CableCreation SATA III 8-inch 6.0 Gbps 5-Pack Blue
Five short SATA III cables with locking latches for tight small-form-factor builds at 6.0 Gbps
- 6 Gbps throughput with SATA 3.0 revision
- Backwards compatible with SATA 1 and 2 revisions
- 8-inch length fits Mini ITX and Intel NUC builds
- Locking latch on each end prevents accidental disconnection
- Five cables included for multiple drive connections
Five-cable SATA III pack
This five-pack supplies 8-inch SATA III cables rated for 6.0 Gbps throughput. Each cable uses a straight-to-angled connector layout with locking latches on both ends. The short 0.2 m length targets Mini-ITX builds, Intel NUC units and other small-form-factor systems where longer cables would clutter the chassis. Buyers who need longer runs for full-size towers should look elsewhere.
Replaces loose or ageing SATA leads
The cables step in when factory-supplied leads are too long, lack locking latches or have developed intermittent contact after repeated drive swaps. Moving from unlocked to latched connectors removes the most common cause of dropped drives in vibration-prone small cases. The jump is worth it when a build has no room for cable routing and every millimetre of clearance counts.
Tool-free press fit with latch verification
Push each connector until the latch clicks; no screws or clips are required. The angled plug seats against the drive edge, so confirm the drive orientation before pressing to avoid blocking adjacent ports. The only common issue is forgetting to depress the latch when removing the cable, which can bend the header pin if forced.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $14.99
- Pricier than about 55% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Will the 8-inch straight-to-angled SATA connectors fit inside a Mini ITX or Intel NUC case?
The 8-inch length is designed for Mini ITX, Intel NUC and other small form factor computers, with a straight connector on one end and an angled connector on the other for tight spaces.
How do I secure the locking latch so the cable does not disconnect during use?
Push each connector fully onto the SATA port until the metal latch clicks into the port's notch; the latch must audibly click to lock the cable in place.
When should I replace one of the five blue SATA III cables in the pack?
Replace a cable if the locking latch no longer clicks, the connector feels loose, or you see bent pins or damaged insulation on the 7-pin ends.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATAPOWADPL 6 in 4 pin Molex to left angle SATA power adapter cable
- 6 in (15.2 cm)
- Cable Connectors
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
BENFEI 000306black-6p SATA cable 6 pack 18 inch 90 degree locking latch black
- Male-to-Male
- SATA III
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Cable Matters 104008-24x3 3-Pack 90° SATA Cable 24in Red
- Sata
- SATA





