CableCreation SATA III cable 5-pack 18-inch 90-degree locking latch blue
Five SATA III cables with 90-degree locking connectors, 18-inch length, 6.0 Gbps throughput
- SATA III 6.0 Gbps speed with backwards compatibility to SATA I and II
- 90-degree right-angle connectors improve cable routing in tight case spaces
- Locking latches on both ends prevent accidental disconnection during use
- 18-inch length suits standard drive-to-motherboard distances
- Five-cable pack provides spares for multiple drives or future builds
Five-cable pack for SATA builds
This pack supplies five 18-inch SATA III cables rated for 6.0 Gbps throughput. Each cable carries a straight female connector on one end and a 90-degree female connector on the other. The blue colour coding helps identify runs inside a chassis. Builders fitting multiple drives or optical units get a consistent set in one purchase.
Locking latch holds under vibration
A locking latch on both ends prevents the cable from working loose when the system is moved or when drives spin up. The right-angle plug reduces strain on the motherboard header and keeps the wire close to the board surface. Backwards compatibility with SATA revision 1 and 2 means the same cables work with older controllers without reconfiguration.
Replaces loose or short OEM leads
The 1.5 ft length suits mid-tower layouts where standard cables fall short or run across airflow paths. The 90-degree angle clears tall heatsinks or crowded drive cages that block straight plugs. Buyers who need longer runs for full-tower cases or external enclosures should measure their routing before ordering.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $13.99
- Typical for this category: the median of 1,954 items is $13.99.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Do the 90-degree connectors add heat or noise when drives run all day?
The cables are passive copper links with no active components, so they generate no heat or noise regardless of how long the drives operate.
What must my motherboard or controller provide for these cables to work?
Each cable needs a standard 7-pin SATA data port on the host side; the board or controller must expose that connector.
Will the 90-degree locking latch fit cleanly beside older straight SATA ports on the same board?
The right-angle plug sits closer to the PCB, which often clears adjacent straight connectors better than a straight plug would.
More in SATA & eSATA Drive Cables
Similar items
DKARDU NR-US-050 4-pack 22-pin SATA combo extension cable 50cm
- Optical
- SATA
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
AYECEHI SATA III 6.0 Gbps cable 90° locking latch blue 12 inch 6 pack
- Sata
- Male-to-Male
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors





