Darkside Computer Modding CONNECT 12" 3-Pin Type 1 DS-0322 internal power cable
A 12-inch 3-pin power extension cable for connecting LED mods to a motherboard or fan controller
- Cable length1 ft (0.3 m)
- Universal 12" power extension for flexible LED modding
- 30 cm length reaches components without excess cable
- 3-pin fan connector fits motherboard or fan controller
- Type 1 design enables quick connectivity changes
- Reduces clutter in custom builds with clean routing
Universal power extension cable
The DarkSide CONNECT 12" cable provides a 3-pin fan power extension for custom computer builds. It is designed for modders who need flexible routing to reach LED lighting or fan headers. The cable simplifies connectivity changes without replacing the entire LED product. It suits builders tidying cable runs inside a case.
3-Pin Type 1 connector
This cable uses a 3-pin fan power connector designated as Type 1. That interface allows direct connection to a motherboard fan header or a compatible fan controller. The single specification determines whether the cable matches the target header on the board or controller. Verify the header pin count before purchase.
12-inch length for tight routing
At 12 inches (30 cm) the cable bridges short gaps between components and headers. It reduces excess slack that adds clutter in compact custom systems. The length frees up space around the motherboard tray while keeping the connection secure. It works alongside other DarkSide CONNECT cables for a consistent modding setup.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $1.60
- Cheaper than about 99% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Size & build | |
|---|---|
| Cable length | 1 ft (0.3 m) |
Questions about this item
How far will the 12-inch length reach inside my case?
The cable measures 12 inches (30 cm), giving enough slack to route from a motherboard header to a fan or LED strip without pulling tight.
What does the 3-Pin Type 1 connector actually plug into?
Type 1 fits a standard 3-pin fan header on a motherboard or fan controller, carrying power and tachometer signal for PWM or voltage control.
What clearance do I need to route this cable behind the motherboard tray?
A flexible 12-inch (30 cm) sleeve with a low-profile 3-pin plug fits through typical grommets and tight routing channels in modern cases.
More in Internal PSU & Riser Cables
Similar items
Darkside Computer Modding DS-0819 Molex 4-pin to dual 3-pin Y-cable 12V 30cm Black
- Black
- Simple power Y-cabl…
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Phobya 6-pin VGA Connector Ver. 1 incl. pins 2ct Male 82379
- Black
- Two sets of Phobya…
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…
Darkside Computer Modding CONNECT Pass-Through Cable 4" 3-Pin Type 3s DS-0365
- 4 in (10.2 cm)





