Darkside USB to 12V Fan Adapter Cable 50cm Black DS-1043
Converts a USB port to 12 V for a single 3-pin or 4-pin fan with a 50 cm cable
- Cable length1.6 ft (0.49 m)
- Powers 12 V fans from a USB port using built-in step-up transformer
- Draws up to .5 A on USB 2.0 and .9 A on USB 3.0 without exceeding spec
- 4-pin connector fits both 3-pin and 4-pin fans for broad compatibility
- 50 cm length gives flexible routing inside compact cases
- Black Jet Back sleeving protects wires and keeps build looking clean
USB 12 V fan adapter for low-power cooling
This cable converts a standard USB port into a 12 V supply for a single 3-pin or 4-pin fan. It is intended for builders who need a simple way to run a case or radiator fan from a motherboard header or powered hub without a dedicated fan controller.
Limited by USB current specifications
The integrated step-up transformer delivers 12 V but the source port caps available current at .5 A on USB 2.0 or .9 A on USB 3.0. Fans drawing more than the port rating will not spin reliably and may trigger port protection, so only low-power models are suitable.
Check fan current draw
Verify the fan’s rated amperage stays below the limit of the USB port you plan to use. A 50 cm / 1.6 ft cable length restricts placement to devices near the port, and the single 4-pin connector supports one fan only.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $4.99
- Cheaper than about 95% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Size & build | |
|---|---|
| Cable length | 1.6 ft (0.49 m) |
Questions about this item
Which length should I pick for a standard ATX case?
The cable is 50 cm long, which reaches most rear or top fan mounts from a motherboard USB header or rear port.
What does the 12 V output mean for my fan?
The built-in transformer steps the USB 5 V supply up to 12 V so a standard 12 V PWM or voltage-controlled fan runs at full speed.
How does the USB 2.0 versus 3.0 port affect the fan I can connect?
On a USB 2.0 port the adapter is limited to 0.5 A, so the fan must draw 0.5 A or less; on a USB 3.0 port the limit rises to 0.9 A.
More in Internal PSU & Riser Cables
Similar items
Nippon Labs POW-S6800-6IN 6.1" Molex to 2 x SATA 15-pin internal power cable
- 6.1 in (15.5 cm)
- 1x Molex LP4 male
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Micro Connectors ATX 12V 4-Pin CPU Power Extension Cable 8 Inches
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…
Dimastech BT111 Black & Red Switch Cables 600mm 2-Pin I/O
- 1.97 ft (0.6 m)





