Arctic Silver AS5-3.5G thermal paste 3.5g tube
- 3.5g
- -50 to 130 °C
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of 100 blue 10×10×1.0 mm silicone pads rated at 3.2 W/mK for filling gaps between chips and heatsinks
This kit supplies one hundred pre-cut conductive silicone pads measuring 10 by 10 by 1.0 millimetres. Each pad offers thermal conductivity of 3.2 W/mK and a breakdown voltage above 4 kV. The blue material is soft, slightly tacky and electrically insulating. It suits control boards, LED modules, laptop internals and similar compact cooling tasks.
The pads maintain performance across a continuous temperature range of minus 40 to 200 Celsius. Their tensile strength of 180 kgf/cm² resists mechanical stress during long-term compression. The silicone stays pliable and retains its gap-filling ability without drying out. This stability keeps thermal resistance low during extended operation.
A 1.0 millimetre thickness and 3.2 W/mK conductivity set the practical thermal resistance for this interface. Gaps larger than the pad thickness cannot be bridged without stacking, which adds resistance. The material is not intended for large-area CPU or GPU dies that demand higher conductivity or thinner bond lines. Users needing lower resistance must select a different specification.
Measured against everything we stock in Thermal Paste, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The pads conduct heat at 3.2 W/mK and stay stable from -40 °C to 200 °C, so they handle continuous GPU loads without drying out.
You need a clean heatsink surface and the correct gap thickness; the 1 mm pads replace existing thermal material between the chip and cooler.
Each 10×10 mm square covers common legacy chipsets and VRMs, and the soft 1 mm thickness conforms to uneven surfaces on older boards.
More in Thermal Paste
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?