EN-Labs 2IDE2CPIE66 internal power cable 6 inch PCIe 6+2 pin to dual Molex 4 pin 18AWG
Converts two Molex 4-pin connectors into a PCIe 8-pin (6+2) plug using 18AWG tinned-copper wire over a 6-inch length
- Connector count3
- Connector genderMale to Female
- Product typeCable Splitters
- Product colorMulti-Color
- Overall length6 in - 10 in
- DetailsWire Gauge: 18AWG Tinned Copper Cable Length: 6 in Connector
- Powers 6-pin or 8-pin graphics cards from dual Molex connectors
- 18 AWG tinned copper conductors carry 12 V DC reliably
- 6 inch length keeps cable routing tidy inside the case
- Female PCIe 6+2 pin plugs directly into GPU power socket
- Two male Molex 4-pin plugs draw power from existing PSU leads
EN-Labs 2IDE2CPIE66 cable
This 6-inch adapter converts two Molex 4-pin connectors from a power supply into a single PCIe 8-pin (6+2) connector. It enables graphics cards requiring PCIe power to run on PSUs that lack native PCIe cables. The 18AWG tinned copper conductors carry 12V DC to the card. Builders upgrading older systems or using modular PSUs without spare PCIe leads will find this cable useful.
Thermals noise and power
Passive copper wiring produces no audible noise and adds negligible thermal load inside the case. The 18AWG gauge is rated for the current drawn by typical 6-pin or 8-pin GPU power inputs at 12V DC. No active cooling or fan control is involved. Power delivery depends entirely on the host power supply's Molex rail capacity.
Bundled accessories and software
No software, drivers or additional accessories are included with this cable. The only change it makes is the physical connection between two Molex plugs and the graphics card's PCIe socket. Compatibility is limited to GPUs equipped with standard 6-pin or 8-pin power inputs. Systems without two free Molex connectors cannot use this adapter.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $4.99
- Cheaper than about 95% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Brand name | En-Labs |
| Model name | 2IDE2CPIE66 |
| Product type | Cable Splitters |
| Product color | Multi-Color |
| Ports & slots | |
| Connector count | 3 |
| Connector gender | Male to Female |
| Size & build | |
| Overall length | 6 in - 10 in |
Questions about this item
How do I connect the 6 inch 18AWG cable from my PSU's two Molex 4-pin connectors to a GPU needing an 8-pin PCIe plug?
Plug both Molex males firmly into separate PSU rails, then seat the 6+2 PCIe female onto the card until the latch clicks; the short 6 inch length leaves no slack, so route before locking.
Will the tinned-copper conductors or Molex terminals degrade and need replacement?
The 18AWG tinned copper resists oxidation, and Molex 4-pin terminals are rated for many mating cycles; no scheduled replacement is required unless a connector shows melted plastic or loose grip.
At what load does the 12 V DC adapter hit its thermal limit during sustained gaming?
The 18AWG wires are rated for 12 V DC delivery; sustained loads near the connector's 12 A per pin spec will warm the cable first, so keep total GPU draw within the PSU's Molex rail rating.
More in Internal PSU & Riser Cables
Similar items
Nippon Labs POW-S6800-6IN 6.1" Molex to 2 x SATA 15-pin internal power cable
- 6.1 in (15.5 cm)
- 1x Molex LP4 male
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Micro Connectors ATX 12V 4-Pin CPU Power Extension Cable 8 Inches
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…
Qinghai Electronics 20-Piece Cable Comb Set — 16×8-pin, 4×24-pin, Silver
- Silver





