EN-Labs SATA cable 10 inch 90° to 180° locking UV Red
A 10-inch SATA cable with a 90-degree latch connector to a straight 180-degree plug, supporting 6.0 Gbps data transfer over shielded 26 AWG copper conductors
- Connector count2
- Connector details1 x SATA to 1 x SATA
- Connector genderFemale to Female
- Conductor typeCopper Conductor
- Product typeSATA III
- Overall length6 in - 10 in
- Secure latch prevents accidental disconnection
- 90° to 180° angled connectors fit tight drive bays
- 10-inch length reduces cable clutter inside case
- 26AWG tinned copper conductors support 6.0 Gbps SATA III speeds
- UL listed and RoHS compliant for safety and environmental standards
What it is and who uses it
The EN-Labs SATA III cable carries data between a 2.5-inch drive and a motherboard or host controller at up to 6.0 Gbps. One end bends 90 degrees and the other sits straight at 180 degrees, each fitted with a locking latch. The 10-inch length suits compact builds where a standard straight cable would foul other components. IT technicians keep spares for quick drive swaps and DIY builders use it when adding a second SSD or HDD.
Check before ordering
Verify that both the drive and the host port use the standard 7-pin SATA interface. The 90-degree connector needs enough clearance beside the drive to seat fully, while the straight end must reach the motherboard port without tension. The cable is rated for SATA I, II and III speeds, so the actual throughput will match the slowest device in the chain. No power lines are included; a separate SATA power lead is required.
Behaviour under sustained load
Shielded 26AWG tinned copper conductors maintain signal integrity during long sequential transfers such as disk imaging or large batch copies. The locking latches resist vibration that can unseat loose plugs in densely packed cases. UL listing and RoHS compliance confirm the materials meet recognised safety and environmental standards for continuous operation inside a running system.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $6.99
- Cheaper than about 85% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Product type | SATA III |
| Design style | 1 Angle |
| Ports & slots | |
| Connector count | 2 |
| Connector details | 1 x SATA to 1 x SATA |
| Connector gender | Female to Female |
| Size & build | |
| Overall length | 6 in - 10 in |
| Cable shielding | Yes |
| Conductor type | Copper Conductor |
Questions about this item
Does the package include only the 10-inch SATA cable or are mounting screws also supplied?
The box contains one 10-inch SATA III data cable with a 90-degree connector on one end and a straight 180-degree connector on the other; no screws or additional hardware are included.
Should I choose a straight-to-straight cable instead of this 90-degree-to-180-degree version for my build?
Pick the 90-degree-to-180-degree cable when the drive sits close to the motherboard edge and a right-angle plug clears the case panel, while the latched straight end secures to the board.
Will the 6.0 Gbps rating actually deliver that speed with my SATA III SSD?
The cable supports SATA III up to 6.0 Gbps, but real-world throughput is limited by the drive and controller; the 26AWG tinned copper conductors and shielding maintain signal integrity at the rated speed.
More in SATA & eSATA Drive Cables
Similar items
Nippon Labs SATA3L1.5FT-90/180RD 1.5 ft SATA III cable 90 to 180 degree
- 1.5 ft (0.46 m)
- SATA III
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Micro Connectors 12 Inches 15-pin SATA Male to Female Power Extension Cable
- 1 ft (0.3 m)
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
Micro Connectors SATA III straight to right-angle cable 20" black 3-pack
- Black





