Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Internal Mini SAS SFF-8087 cable connects a RAID or PCIe controller to four right-angle SATA drives at 6Gb/s per drive
The EN-Labs SFF80874SATA1M90 links a Mini SAS SFF-8087 host port to four right-angle SATA targets. It suits builders wiring RAID or PCIe controllers to multiple hard drives inside a server or workstation chassis. The 3.3 ft length reaches typical backplane distances without excess slack. Each connector carries a latch for secure seating.
Passive copper construction adds no active heat or noise to the system. The woven mesh sheath covers half the run, protecting conductors while allowing tight bends for clean routing. Power draw is limited to the controller and drives themselves; the cable introduces no additional load.
P1–P4 markers on the SATA ends simplify drive identification after installation. Right-angle SATA plugs reduce strain in crowded drive bays. Compatibility spans common HBA and RAID cards such as the Adaptec 5405, Dell PERC H310, HighPoint RocketRAID 2720SGL and similar SFF-8087-equipped controllers.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | EN-Lab |
| Model name | SFF80874SATA1M90 |
| Product type | Internal mini SAS |
| Product color | Black / Blue |
| Performance | |
| Rated speed | 6Gb/s |
| Ports & slots | |
| Connector count | 5 |
| Connector details | 1 x SFF-8087 to 4 X SATA (Right Angle 90 degree) |
| Size & build | |
| Overall length | 3.3 ft / 1m |
Connect the SFF-8087 male latch connector to the RAID controller port, then attach each right-angle SATA female latch connector to a drive; the step often missed is aligning the right-angle orientation so the latch engages fully without cable strain.
The woven mesh sheath protects the first half of the 1 m length; inspect latch tabs on the SFF-8087 and four SATA connectors periodically and replace the cable if any latch fails to hold or if the sheath shows abrasion.
The 1 m length and shared PCIe 2.0 x8 host bandwidth set the practical ceiling; signal integrity over the Mini SAS 36-pin interface and aggregate controller throughput become the limiting factors before individual drive speed.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?