Arctic Silver AS5-3.5G thermal paste 3.5g tube
- 3.5g
- -50 to 130 °C
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 100 x 100 x 5.0 mm blue silicone thermal pad rated at 3.2 W/m-K for filling gaps between chips and heatsinks
This 100x100mm silicone thermal pad suits DIY repairs on GPUs, northbridge chips, LED modules and similar components needing a 5.0mm gap fill. Its 3.2 W/m-K conductivity targets moderate heat-transfer tasks in consumer electronics and PC builds. The blue colour aids visual identification during assembly.
The pad’s malleable texture conforms to uneven surfaces without mess, while slight tackiness holds it in place during installation. Electrical insulation rated above 4 kV breakdown voltage protects adjacent circuitry, and tensile strength of 180 kgf/cm² resists tearing when repositioning. Continuous operating range spans -40 °C to 200 °C for demanding environments.
At 5.0mm thick the pad cannot accommodate thinner gaps without compression that may reduce performance or stress components. Builders needing different gap sizes must source separate thicknesses, and the single 100x100mm sheet yields limited coverage for larger heatsinks or multiple devices.
Measured against everything we stock in Thermal Paste, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The pad conducts heat at 3.2 W/m-K, moving warmth from GPU, northbridge or LED chips into the heatsink across the full 100 x 100 mm surface.
It requires a flat mating area at least 100 mm square with a 5.0 mm gap between component and cooler; the soft silicone compresses slightly to fill uneven surfaces.
Clean both surfaces, peel the protective film, lay the pad evenly from one edge to the other, then press the heatsink down firmly so the slight viscosity spreads the material without gaps.
More in Thermal Paste
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?