HANNORD SATA Cable III 3-pack 15.75 inch blue
Three blue SATA III cables with locking latches connect drives at up to 6 Gbps over 15.75 inch runs
- Product colorBlue
- Up to 6 Gbps data transfer with SATA 3.0 revision
- Locking latches on both ends secure the connection during operation
- Three cables included for RAID arrays or multiple drive bays
- Compatible with 2.5 SSD, 3.5 HDD and optical drives
- Low-profile 15.75 inch jacket simplifies routing inside the case
Three-cable SATA III kit
This pack contains three 15.75 inch SATA III data cables with blue connectors and locking latches. Each cable links a motherboard or host controller to internal Serial ATA hard drives, solid-state drives or optical drives. The cables carry data only and do not supply power to the connected device.
Builders adding several drives.
The three-pack suits system builders who are wiring multiple 2.5 inch SSDs, 3.5 inch HDDs or DVD drives at once, or who want spares for RAID arrays. Anyone needing only one replacement cable will have two unused cables left over.
6 Gbps SATA Revision 3.0 interface
The cables conform to the SATA 3.0 specification and support transfer rates up to 6 Gbps, while remaining backward compatible with SATA I and SATA II devices. Actual throughput is limited by the speed rating of the drive and controller in use.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $5.99
- Cheaper than about 90% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Product color | Blue |
Questions about this item
What does the 6 Gbps rating actually deliver once the cable is installed?
The cable supports SATA Revision 3.0 at up to 6 Gbps, but the real-world speed is capped by the drive and controller you connect it to.
Which SATA standard does the locking-latch connector follow, and what does that limit?
It uses the 7-pin SATA L-type receptacle defined by SATA III, so the link cannot exceed 6 Gbps even if faster drives appear later.
Will the 15.75 inch length reach a 3.5 inch drive mounted in a full-tower case?
At 15.75 inches the low-profile jacket gives enough slack for most full-tower layouts, but measure your motherboard-to-drive path before routing.
More in SATA & eSATA Drive Cables
Similar items
Micro Connectors 4-Pin LP4 to Left Angle SATA Power Adapter Cable 6 Inches
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Micro Connectors 12" SATA III Straight Cable with Locking Latch Black 3-Pack
- Black
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
Micro Connectors SATA III 20" 90° to 90° Cable with Locking Latch Black 3-Pack
- Black





