Apple MD565LL/A 60W MagSafe 2 Power Adapter
- AC Power
- 60 W, Input: 100-24…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A PCIe 5.0 ReDriver extends 32GT/s signals from an M.2 slot to dual MCIO 38P connectors and a U.3 cable at 100cm
The Innocard EP7102 kit converts an M.2 PCIe 5.0 slot to dual MCIO 38P connectors and includes a 100cm MCIO 38P to U.3 cable. A built-in ReDriver extends 32GT/s differential signals while a clock buffer supports longer trace lengths. Integrated load switching and voltage-level translation handle hot-plug control and sideband signals.
This kit suits builders who need to route PCIe 5.0 from an M.2 slot to U.3 drive bays using standard MCIO 38P cabling. It is not for users without an M.2 PCIe 5.0 host connector or those requiring a direct U.2 or U.3 backplane connection without the intermediate MCIO step.
The on-board ReDriver and 100MHz clock buffer maintain link stability over the 100cm cable run under continuous load. SMBus repeater and PERST# translation keep management paths active during extended transfers. Green and red LEDs confirm 3.3V rail readiness and PERST# status throughout operation.
Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Adapter type | PCIe Gen5 |
Yes, the adapter converts an MCIO 38P connector (SFF-TA-1016) to an M.2 PCIe 5.0 slot, so the host must provide that MCIO 38P interface.
The cable is built to the PCIe 5.0 32 GT/s specification with a ReDriver and clock buffer, so it will also carry PCIe 4.0 signals to a U.3 device.
LED1 green on means 3.3 V power is ready; LED2 red changing from on to off means the PERST# reset signal has de-asserted normally.
More in Other Adapters & Couplers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?