Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts 6–36 V DC to a 5.2 V USB port with 3 A peak output, 96 % efficiency and built-in protection
This step-down buck regulator converts any 6-36V DC supply into a standard USB charging port rated at 5.2V. It suits hobbyists adding USB power to automotive, solar or industrial projects where only higher-voltage DC is available. The tiny 37 by 16 by 9.7 mm board fits inside tight enclosures. Over-current, thermal and short-circuit protection guard connected devices.
Peak current reaches 3A, yet continuous delivery settles at 2A to keep thermals manageable. Conversion efficiency climbs to 96 percent, so waste heat stays low during extended charging sessions. The 150 kHz switching frequency helps maintain stable voltage under varying loads. Builders should plan for the lower sustained figure when sizing the upstream supply.
Four through-hole pads accept standard headers or direct wiring for permanent mounting. Correct input polarity is essential; reversing the supply will damage the module. The wide input range tolerates 12V and 24V vehicle systems without adjustment. Users needing quick-disconnect plugs must add their own connectors.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | JacobsParts |
| Model name | USBMOD-F |
| Product type | Step Down (Buck) Voltage Regulator |
| Power | |
| Supply voltage | 5 V |
| Current rating | 3 A |
| Rated power | 15 W |
The module runs at 150KHz with up to 96% conversion efficiency, so waste heat stays small even at the 2A sustained output.
You need a 6-36V DC supply such as a 12V or 24V battery or adapter, plus wires to connect its terminals to the module’s input pads.
Yes, the 5.2V rail only delivers the current the phone requests, so a 1A handset draws 1A safely.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?