Phobya 4-Pin PWM Male-to-Male 30cm Fan Cable Adapter (1012290) Black
A 30 cm black PWM fan cable with male connectors on each end for DIY cable management and fan controllers
- Product colorBlack
- 30 cm length gives flexible routing inside cases
- 4-pin PWM connectors carry speed control signals
- Male-to-male design links fan directly to controller
- Black sheath keeps build aesthetics consistent
- Supports DIY cable management for tidy airflow
PWM fan extension cable
The Phobya 4-pin PWM male-to-male adapter extends a fan connection by 30 centimetres. It carries both power and speed-control signals between a fan and a motherboard header or fan controller. The black sleeving matches typical case interiors. Builders who need a longer PWM link for tidy routing will find it useful.
Suits custom loops and tight routing.
The cable works with any standard 4-pin PWM fan or controller that follows the common pinout. It helps when the stock lead falls short in large chassis or behind radiator stacks. Buyers whose fans use 3-pin voltage control cannot use PWM regulation through this adapter. Systems that require a female socket on one end should choose a different cable.
Male-to-male ends enable direct fan-to-header links
Each end terminates in a 4-pin PWM male plug so the cable bridges two female ports without extra couplers. This simplifies cable management in custom water-cooling loops and fan-wall builds. No software, splitters or additional connectors are bundled with the adapter.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $10.99
- Cheaper than about 65% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Product color | Black |
Questions about this item
What fan header type must my motherboard or controller provide for the Phobya 4-pin PWM male-to-male adapter to work?
The adapter uses a standard 4-pin PWM connector, so the header on your motherboard or fan controller must also be a 4-pin PWM header.
Can I keep using my existing 3-pin voltage-controlled fans with this 4-pin PWM male-to-male cable?
The cable carries a PWM signal on the fourth pin; a 3-pin fan will run but cannot receive PWM control, so speed regulation will fall back to voltage mode if the header supports it.
How can I confirm the Phobya 30 cm PWM cable is delivering a PWM signal after I connect it?
In BIOS or fan-control software, set a custom curve; the attached fan should follow the curve instead of staying at a fixed speed.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
iKKEGOL USB 2.0 to 2.5" 3.5" 5.25" SATA OTB Adapter
- 3 ft (0.91 m)
- 1 x eSATA to 1 x eS…





