SANOXY Cat6A network ethernet cable 3FT Blue 10Gbps 500MHz 26AWG 50-micron gold RJ45 non-booted STP
A shielded Cat6A patch cable with 26AWG pure copper conductors and 50-micron gold RJ45 contacts, supporting 10Gbps at 500MHz for short, high-density connections
- 10 Gbps speed and 500 MHz bandwidth for high-performance networking
- Shielded STP construction reduces electromagnetic interference and crosstalk
- 26 AWG pure bare copper conductors ensure excellent conductivity and minimal signal loss
- Non-booted RJ45 connectors save space in high-density network environments
- 50-micron gold-plated contacts provide corrosion resistance and stable long-term performance
Ideal for tight patch-panel runs
This 3 ft Cat6A patch cord is built for short, high-density connections between switches, patch panels or side-by-side equipment. Shielded STP construction and 26 AWG pure copper conductors deliver 10 Gbps throughput at 500 MHz bandwidth. The non-booted RJ45 plugs with 50-micron gold contacts save space and resist corrosion in crowded racks.
Replaces longer unshielded cords
Swap out standard Cat5e or unshielded Cat6 cables when electromagnetic interference degrades signal integrity in dense cabinets. The upgrade is justified where crosstalk or EMI from adjacent hardware causes packet loss or speed negotiation failures. Shielding and higher bandwidth headroom keep 10 Gbps links stable without re-terminating existing infrastructure.
Tool-free press-fit installation
Push the non-booted connectors directly into keystone jacks or switch ports; no crimping or boot removal is required. The slim profile eases routing through packed cable managers. The only common issue is accidental unplugging if the latch tab catches on neighbouring cables — route with a slight service loop to prevent tension on the plug.
How it compares
Measured against everything we stock in Ethernet & LAN Cables, at today’s prices. Recalculated every night.
- Price $9.99
- Cheaper than about 73% of the 9,917 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Other versions of this model
5 more in the same range
SANOXY Cat6A network ethernet cable .5FT STP 10Gbps 500MHz 26AWG gold 45 non-booted Blue
SANOXY Cat6A Ethernet Cable 3FT Shielded STP 10Gbps 500MHz 26AWG Gold Plated RJ45 Non-Booted Black
SANOXY Cat6A network ethernet cable .5FT 10Gbps 500MHz 26AWG STP non-booted RJ45 50-micron gold black
SANOXY Cat6A Shielded STP Patch Cord 2FT 10Gbps 500MHz 26AWG Gold RJ45 Non-Booted Black
Questions about this item
What clearance is needed for the non-booted RJ45 connectors?
The non-booted RJ45 connectors fit tight patch panels and switch ports without extra boot space, ideal for high-density racks where cables sit side by side.
How do I terminate or seat the shielded STP cable correctly?
Push each RJ45 plug until it clicks; the shielded design requires full insertion so the drain wire contacts the jack ground, otherwise EMI protection is lost.
Will the 50-micron gold-plated contacts need re-termination over time?
The 50-micron gold plating resists corrosion on the 26AWG pure copper conductors, so the connectors maintain stable contact without re-termination for the cable's service life.
More in Ethernet & LAN Cables
Similar items
Cables To Go 31360 Cat6 network ethernet cable 75 ft Gray
- RJ45
- RJ45
Nippon Labs 60CAT6A-5YW network ethernet cable Cat6A UTP 5 ft Yellow 24AWG RJ45
- 6A
- RJ45
Belkin A3X126-07-YLW-M Cat5e Crossover Network Ethernet Cable 7 ft Yellow
- 5E (Crossover)
- Consumer Electronics
aibileec Network Ethernet Cable Black 25 ft CAT-7
- 25 ft (7.62 m)
- Black
Belkin A3L791-06 network ethernet cable Cat 5E 6 ft Gray
- 5E
- Consumer Electronics
aibileec network ethernet cable 25 ft black CAT-8
- 25 ft (7.62 m)
- Black










