SATAGear R-SS-1MRL SATA cable 36-40in right to left angle red
A 36 to 40 inch red SATA cable with right-angle to left-angle connectors for internal drives, supporting up to 6.0 Gbps transfer rates
- Product colorRed
- Overall length36 in - 40 in
- Right-angle connectors fit tight drive bays
- 36-40 inch length suits full-tower cases
- 0 Gbps transfer rate for SATA III drives
- Shielded cable reduces EMI and RFI interference
- Narrow profile improves internal airflow
Right-to-left angled SATA cable
This 36 to 40 inch red cable connects a Serial ATA drive to a controller using dual 7-pin female connectors. One end angles right and down while the other angles left and up for tight routing. The shielded design supports transfer rates up to 6.0 Gbps and meets Serial ATA 1.0 Standards.
Replaces straight or single-angled cables
Use this cable when straight connectors press against a drive cage, side panel or adjacent card. The opposing right and left angles let the cable hug the motherboard edge and drive bay without sharp bends. The jump is worth it when standard cables block airflow or cannot reach the port cleanly.
Check port orientation and spacing
Verify the motherboard SATA port faces the direction the right-angle plug requires. Confirm the drive connector accepts the left-angle plug without hitting the chassis wall. Measure the run between the two ports so the 36 to 40 inch length provides slack without excess coil. Ensure the controller and drive both use standard 7-pin SATA interfaces.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $0.78
- Cheaper than about 99% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Model name | R-SS-1MRL |
| Product color | Red |
| Size & build | |
| Overall length | 36 in - 40 in |
Questions about this item
What clearance does the right-to-left angled 7-pin connector need at the drive and controller ends?
The right-angle connector points downward at the drive and the left-angle connector points upward at the controller, so allow space for each bend to sit flush against the port without cable strain.
How do I connect the dual 7-pin female connectors without reversing the angled ends?
Push the right-angle end onto the device port until it clicks, then route the cable and seat the left-angle end on the controller port; the keyed L-shape prevents upside-down insertion.
When should I replace this shielded SATA 1.0 cable to keep 6.0 Gbps signal integrity?
Replace it if the red jacket shows kinks, the shielding is exposed, or connectors feel loose, as physical damage degrades the 6.0 Gbps link before total failure occurs.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Darkside DS-0767 6mm Metallic Red Sleeving 1ft
- Red
- Tired of your cable…
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA





