SATAGear SS-01MSS SATA cable 4 in straight to straight
A 4-inch internal SATA III cable with straight 7-pin female connectors on both ends, supporting 6.0 Gbps data transfer and a narrow, shielded design for improved airflow
- Cable length4 in (10.2 cm)
- SATA III revision 3.0 supports up to 6.0 Gbps throughput
- 4-inch length keeps cable routing tidy inside the case
- Narrow cable design improves internal airflow around components
- Dual 7-pin female connectors fit standard SATA devices directly
- Shielded construction protects signals from EMI and RFI interference
4-Inch Internal SATA III Cable
This 4-inch internal cable connects Serial ATA drives and optical devices to a motherboard or controller. Both ends carry a straight 7-pin female connector for a direct device-to-board link. It is built for tight spaces inside desktops or servers where a short run keeps routing clean.
Builders with stacked drives or cramped bays
The short length suits installations where the drive sits close to the SATA port. Builds that need longer reach between separated components should choose a different cable. The straight connectors also require enough clearance behind the drive for a straight plug.
4-inch cable length
At four inches the cable only spans a very short distance between the drive and the motherboard port. Measure the exact routing path before ordering to confirm the length is sufficient for your chassis layout.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $0.61
- Cheaper than about 99% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Model name | SS-01MSS |
| Size & build | |
| Cable length | 4 in (10.2 cm) |
Questions about this item
What connectors come on the SATAGear SS-01MSS cable and do I need anything else?
The cable has dual 7-pin female SATA connectors on each end. No additional parts are required for a standard internal drive connection.
Which version of this cable should I choose for a 6 Gbps drive?
This model is a SATA revision 3.0 cable rated for up to 6.0 Gbps, so it matches the drive's maximum interface speed.
What does the 6.0 Gbps figure mean when the cable is installed in my system?
It is the peak interface bandwidth of the SATA 3.0 link; actual throughput depends on the drive and controller performance.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
SATACables LP30SR584 SATA cable 23 inch low profile straight to right
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA





