SATAGear SS-05MRR SATA cable 20in right-angle to right-angle 1.66 ft 6.0 Gbps
A 20-inch SATA cable with right-angle connectors on both ends for tight internal routing
- Cable length1.66 ft (0.51 m)
- Right-angle connectors simplify routing in tight cases
- 20 in length reaches drives across full-size chassis
- Shielded construction protects signals from EMI and RFI
- Narrow cable design improves internal airflow
- Supports up to 6.0 Gbps data transfer rates
Product identity
The SATAGear SS-05MRR is a 20in internal SATA cable with right-angle 7-pin female connectors on both ends. It supports data transfer rates up to 6.0 Gbps and meets Serial ATA 1.0 standards. Builders adding or repositioning Serial ATA hard drives, optical drives or other SATA devices in a desktop or server will find the angled plugs useful where straight connectors foul adjacent components.
Before ordering
Check that your motherboard or controller provides standard 7-pin SATA ports and that the right-angle orientation points the cable in the needed direction. The 1.66 ft length suits typical chassis routing but measure the run from port to device to be sure. The cable carries signal only; power must come from a separate SATA power connector on your PSU.
Build and daily use
A narrow, shielded jacket resists EMI/RFI and leaves more room for airflow than wide ribbon cables. Dual 7-pin female ends lock securely onto device and controller ports. The right-angle moulding keeps the cable close to the board or drive, easing routing in tight drive cages and reducing strain on the port during drive swaps.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $0.51
- Cheaper than about 99% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Model name | SS-05MRR |
| Size & build | |
| Cable length | 1.66 ft (0.51 m) |
Questions about this item
What connectors come on the cable and is any extra hardware needed?
The cable has a 7-pin female connector at each end, both angled right (down). No additional brackets or adapters are required for a standard SATA device and controller.
Which length should I pick for a typical desktop build?
The 1.66 ft (20 in) length suits most mid-tower cases, letting you route from a motherboard SATA port to a drive bay without excess slack.
What does the 6.0 Gbps rating mean for my drive’s actual speed?
6.0 Gbps is the interface ceiling; real-world throughput depends on the drive itself and the controller, but the cable will not bottleneck any SATA SSD or hard drive.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA





