Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects external Mini SAS SFF-8088 devices at 6Gbps with 26-pin male connectors, 100 Ohm impedance, 30AWG conductors, double shielding and a 6.6ft length for server and storage arrays
This 2 metre SFF-8088 male-to-male cable carries external SAS traffic at up to 6Gbps between servers, RAID controllers and disk enclosures. It uses 30AWG conductors with 100 Ohm impedance and double-layer shielding to maintain signal integrity. Robust metal locking connectors resist vibration in rack environments. The 6.6 foot length suits cabinet cross-connections and external wiring layouts.
IT teams building or expanding storage arrays, JBOD units or NAS appliances at 6Gbps will find the connectors and shielding match enterprise requirements. The cable does not support higher-speed SAS standards, so buyers needing faster links must select a product rated for those rates. It is not intended for internal backplane routing or non-SAS protocols.
The single specification that decides fit is the 6Gbps SAS transmission rating; the cable is validated for this speed with 26-pin SFF-8088 ends, 30AWG wire and 100 Ohm impedance. Verify that both host and target equipment operate at this rate before purchase.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Check the controller BIOS or management utility for a negotiated link speed of 6Gbps on each port and confirm zero CRC or phy errors during sustained read and write workloads.
The cable has SFF-8088 26-pin male connectors on both ends with double-layer shielding and metal locking latches; no adapters are required for standard SFF-8088 ports.
Choose this 2 metre length for typical rack-to-rack or server-to-JBOD runs where 6.6 feet provides enough slack without excess cable, and 30AWG 100 Ohm construction meets the 6Gbps signal-integrity requirement.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?