Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects four SATA drives to a RAID controller at 6Gbps with 50cm shielded cable and gold-plated pins for 24-hour server operation
This 50cm internal cable connects four SATA 7Pin male host ports to four SATA 7Pin male target ports, enabling multiharddisk connections inside servers, NAS units and storage arrays. It supports up to 6Gbps bandwidth and works with SATA III hard drives, solidstate drives and RAID controller cards. Shielded conductors reduce crosstalk and electromagnetic interference during heavy readwrite workloads. Goldplated pins resist oxidation for steady 24hour operation.
The cable suits professionals building rack servers, configuring RAID sets or upgrading multidrive chassis where tidy 50cm routing is required. It is not for buyers who need external drive connectivity or longer runs between separate enclosures. Enthusiasts without internal SATA host ports should look at other solutions.
The single specification that decides fit is the four-port 7Pin male host to four-port 7Pin male target arrangement, which matches controllers and backplanes expecting this exact connector pattern. Verify your hardware uses the same pin layout before purchase.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Connect the four host-end SATA 7Pin male plugs to the RAID controller or motherboard ports, then attach the four target-end SATA 7Pin male plugs to the drives, routing the 50cm length to avoid sharp bends; the common mistake is reversing host and target ends.
The gold-plated pins resist oxidation for 24/7 operation, so no routine cleaning is required; replace the cable only if physical damage or intermittent drive detection appears after prolonged use.
The 6Gbps per-lane bandwidth ceiling is the first bottleneck under heavy simultaneous read-write traffic across all four SATA channels.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?