Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts a single 38-pin Slimline SAS SFF8654 4i port into four SATA connections for server storage expansion
This cable converts a single 38pin Slimline SAS SFF8654 4i port into four independent SATA connections. It is built for server administrators and integrators who need to attach SATA hard drives or solidstate drives to a Slim SAS controller in enterprise servers and workstations. The 1to4 breakout design supports highspeed stable transmission for RAID configurations and storage expansion. Shielded construction reduces signal loss and electromagnetic interference inside dense chassis.
The cable fits builders who have a controller exposing the SFF8654 4i interface and want to run up to four SATA devices without a backplane. It is not for systems that only provide standard Mini SAS or legacy SCSI connectors. It is also not for installations that require a different pin count or a straightthrough cable rather than a breakout design.
The decisive specification is the 1to4 breakout from one 38pin Slimline SAS SFF8654 4i connector to four SATA ports. If the host controller presents this exact interface and the target drives use SATA, the cable completes the link. If the controller uses any other connector type or the drives require a different protocol, this cable will not fit.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The Slimline SAS plug is low-profile so it fits in tight server bays; allow room for the four SATA tails to route to each drive without sharp bends.
Seat the 38Pin SFF8654 4i end fully until the latch clicks, then connect each SATA plug to its drive before powering on the system.
Swap it if the shielding shows cuts, the latch no longer holds, or drives drop from the array intermittently.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?