Arctic Silver AS5-3.5G thermal paste 3.5g tube
- 3.5g
- -50 to 130 °C
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
High-performance phase-change thermal pad, 50x40mm, solid at room temperature and liquefies above 45°C for optimal CPU and GPU heat transfer
The Thermal Grizzly PhaseSheet PTM is a 50x40mm thermal pad built on phase-change material. It stays solid at room temperature for clean, easy handling and only liquefies above 45°C to fill microscopic gaps. The pad is non-electrically conductive, making it safe for direct use on CPUs, GPUs and other sensitive electronics.
Optimum distribution of the liquid phase demands a contact pressure of around 300-400N. Without sufficient pressure the pad cannot achieve its lowest possible layer thickness, limiting heat transfer. The material also contracts on solidification to minimise the pump-out effect caused by differing thermal expansion between copper coolers and silicon dies.
Stable thermal conductivity is maintained after about 10 cycles, offering longer service life than traditional pastes but less than premium graphite alternatives. Buyers who need a pad that lasts indefinitely without re-application should consider other solutions.
Measured against everything we stock in Thermal Paste, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Thermal Grizzly |
| Model name | TG-PS-50-40 |
| Part number | TG-PS-50-40 |
The pad measures 50 by 40 millimetres and can be trimmed to fit smaller dies or left full-size for larger heatspreaders.
The material stays solid until the component reaches about 45 °C, then liquefies to fill microscopic gaps and returns to solid when it cools, minimising pump-out over repeated cycles.
Thermal Grizzly specifies roughly 300 to 400 newtons of contact pressure so the liquid phase spreads into the thinnest possible layer for best thermal transfer.
More in Thermal Paste
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?