Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pre-wired 100K NTC thermistor with 1m PTFE-insulated wire, 2.54mm connector, ±1% accuracy from -40°C to +200°C, pack of 5
These NTC 3950 thermistors ship as a five-piece pack with one-metre PTFE-insulated leads and a 2.54 mm pitch two-pin female header. They drop straight into the extruder or heated bed of Ender 3, Ender 3 Pro, Ender 5, CR-10 and CR-10S machines. Each sensor is rated ±1 % accuracy across a -40 °C to +200 °C range, covering both standard and high-temperature filaments. The pre-wired construction removes the need for crimping or soldering during installation.
Builders whose control boards use a different pin pitch or a three-pin header cannot use these without an adapter. The 100 K resistance curve also means they are not a match for printers that expect a 10 K or 50 K thermistor table in firmware. Users needing longer than 3.28 feet of cable or a bare-wire termination should look at other sensor kits.
The single specification that determines compatibility is the 100 K nominal resistance value; the controller firmware must contain the matching 3950 beta curve table for accurate temperature reporting.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
The 2.54mm pin pitch matches the standard JST connector used on Ender 3, Ender 3 Pro, Ender 5, CR-10 and CR-10S printers, so it plugs directly into the stock harness.
At room temperature the resistance should measure near 100K Ohm with a multimeter; the printer firmware should then report a temperature close to ambient, typically within the ±1% accuracy range.
The package contains only the five pre‑wired thermistors with 2.54mm female connectors; no screws, heat‑shrink or crimping tools are supplied.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?