Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Set of ten brass MK8 nozzles for 1.75 mm filament, covering 0.2 mm to 1 mm diameters
This set supplies ten brass nozzles made for MK8-style hot ends that accept 1.75mm filament. It covers five diameters from 0.2mm to 1mm so users can switch between fine detail and fast draft prints. The pack is aimed at hobbyists and small-shop operators who run non-abrasive materials such as PLA, ABS or PCL and want a ready assortment of sizes.
Each nozzle is machined from brass for corrosion resistance and long service life. The M6 thread with a 5mm length screws cleanly into standard MK8 heater blocks, and the size is stamped on the side for quick identification. The bores are consistent and the threads are well formed, reducing the risk of leaks or jams during everyday printing.
Brass works well with non-abrasive filaments but wears quickly with carbon-fibre, glow-in-the-dark or metal-filled materials, so those filaments are not a good match. The largest 1mm bore pushes more plastic but demands higher flow rates that some MK8 setups cannot sustain without tuning. Users must also recalibrate the nozzle-to-bed gap after every swap to maintain first-layer quality.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
They use an M6 thread with a 5 mm thread length and accept only 1.75 mm filament.
Each nozzle measures 13 mm long by 6 mm in diameter, requiring a 6 mm socket or spanner.
Heat the block to 180–220 °C for PLA or 240–280 °C for ABS, then remove the old nozzle while hot.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?