Arctic Silver AS5-3.5G thermal paste 3.5g tube
- 3.5g
- -50 to 130 °C
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 100 mm square silicone pad 1.5 mm thick conducts heat at 1.5 W/m-K between 50 and 200 °C
This blue silicone thermal pad measures 100mm by 100mm with a 1.5mm thickness and provides a thermal conductivity of 1.5 w/m-K. It acts as a compliant gap filler between a heatsink and a component, bridging uneven surfaces to improve heat transfer. The material offers low hardness for damping and cushioning while maintaining good compressibility. It withstands operating temperatures from 50 to 200.
The pad upgrades thermal interfaces where liquid compound has dried out or where a thicker, compressible layer is required to span uneven mating surfaces. The jump is worth it when the gap exceeds what a thin layer of paste can reliably fill and a soft, pre-cut sheet simplifies assembly. Installation requires cleaning the surface, removing the protective film, and placing the pad in position.
This single 100mm square sheet suits builders who need one piece for a specific component such as a voltage-regulator module, memory chip or small GPU heatsink. Buyers who need multiple pads for a full graphics card or large array should look elsewhere, as the pack contains only one piece. The fixed 1.5mm thickness also limits use where a different gap height is required.
Measured against everything we stock in Thermal Paste, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
The pad measures 100mm by 100mm with a 1.5mm thickness, designed to bridge uneven surfaces between a heatsink and component.
Clean the surface, tear off the plastic protective film, then place the exposed pad onto the component before mounting the heatsink.
Replace the pad if it dries out, loses compressibility, or after prolonged exposure near the 200°C upper limit degrades the silicone.
More in Thermal Paste
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?