Arctic Silver AS5-3.5G thermal paste 3.5g tube
- 3.5g
- -50 to 130 °C
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Two 100 mm square by 2 mm soft silicone thermal pads rated at 1.5 W/m-K conductivity and a 50 to 200 °C operating range fill gaps between heatsinks and components for improved heat transfer
These 100 mm square silicone pads sit between a heatsink and a component to fill air gaps and improve heat transfer. Each sheet is 2 mm thick and rated at 1.5 w/m-K conductivity. The pack contains two blue pads that are soft enough to compress and cushion the mating surfaces. They suit builders who need a tidy, pre-cut alternative to paste for memory modules, VRM arrays or small chipsets.
Unlike thermal grease, these pads leave no residue and cannot pump out over time. The jump is worth it when the contact faces are uneven or when a component sits slightly lower than the heatsink base, because the 2 mm thickness bridges the gap without excessive pressure. They are not for buyers who need the absolute lowest thermal resistance on a perfectly flat CPU die, where a thin layer of quality paste still outperforms a 2 mm silicone layer.
The material withstands temperatures from 50 to 200 °C, so it survives normal operating ranges but cannot match high-end pads rated above 5 w/m-K. At 2 mm thick the thermal path is longer than a typical paste line, which adds resistance on high-power devices. Installers must clean surfaces, peel both protective films and apply even pressure; the pads cannot be reused once compressed.
Measured against everything we stock in Thermal Paste, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
The pad is 2 mm thick and compresses to bridge uneven surfaces, so it suits gaps close to that dimension.
Clean the component surface, then peel the plastic protective film from both sides of the pad before positioning it.
The pad withstands 50 to 200 °C; replace it if it hardens, cracks or no longer compresses after prolonged exposure near the upper limit.
More in Thermal Paste
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?