Vszerda 18AWG Molex 4-pin Y splitter 1M-2F 20cm 2pcs
Splits one Molex 4-pin connector into two for drives and fans, 20 cm 18 AWG tinned-copper cable with braided sheath, pack of two
- Connector detailsMolex 4 Pin
- Expands one Molex connector into two independent ports
- Compatible with hard disks, cooling fans and optical drives
- Plug-and-play installation requires no driver setup
- Tinned copper cores with PVC insulation and nylon braided sheath
- Standard 1007 18 AWG gauge cable at 20 cm length
Splitter cable for Molex devices
This 18 AWG Molex Y splitter turns one LP4 male connector into two female connectors, letting you power two drives or fans from a single rail. Each cable measures 20 cm and the pack contains two splitters for multiple devices. The tinned copper conductors and braided nylon sheath resist wear and heat inside the case.
Builders with spare Molex headers
Suits anyone adding a second hard disk, optical drive or case fan when the power supply has unused Molex leads. Not for systems that only provide SATA power connectors or builders who need longer reach than 20 cm between the supply and the device.
Wire gauge and length
Rated to the 1007 18 AWG standard, the conductors handle typical peripheral currents without voltage drop over the short 20 cm run. The fixed length keeps cable clutter low but limits placement in large chassis where devices sit farther from the supply.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $14.99
- Pricier than about 55% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Brand name | YARCHONN |
| Model name | YR-250088DL1 |
| Ports & slots | |
| Connector details | Molex 4 Pin |
Questions about this item
Will the 18 AWG tinned copper wires on this splitter handle the same load as the original Molex lead from my power supply?
Yes, the 18 AWG gauge matches standard PSU Molex wiring, so the splitter carries the same current without adding resistance.
How can I confirm the Y splitter is delivering power to both connected devices after installation?
Both devices — such as hard disks or cooling fans — will spin up immediately when the system powers on, confirming each female connector is live.
Does the pack include any mounting clips or SATA adapters, or just the two 20 cm braided splitter cables?
Only the two 20 cm Molex 1‑male‑to‑2‑female splitter cables are included; no clips, SATA adapters or extra hardware are supplied.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATAPOWADPL 6 in 4 pin Molex to left angle SATA power adapter cable
- 6 in (15.2 cm)
- Cable Connectors
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
BENFEI 000306black-6p SATA cable 6 pack 18 inch 90 degree locking latch black
- Male-to-Male
- SATA III
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
Cable Matters 104008-24x3 3-Pack 90° SATA Cable 24in Red
- Sata
- SATA





