Vszerda 4 Port SATA 3.0 PCIe 3.0 X1 Controller Card Marvell 88SE9215
Adds four SATA 3.0 ports at 6.0 Gbps via a PCIe 3.0 x1 slot using the Marvell 88SE9215 chip, supports boot drives and hot swap
- Add four SATA 3.0 drives at 6.0 Gbps
- Works with older SATA 1.5 and 3.0 Gbps drives
- Marvell 88SE9215 chip for broad compatibility
- Fits any PCIe x1, x4, x8 or x16 slot
- Boot from SSD or HDD in AHCI mode
Add Four SATA 3.0 Ports
This Vszerda controller card adds four 6 Gbps SATA 3.0 connections through a single PCIe 3.0 x1 slot. The Marvell 88SE9215 chip provides backward compatibility with 1.5 and 3 Gbps drives. It supports AHCI and IDE modes for broad operating system support.
Suits Builders Needing Extra Internal Drives
Ideal for adding multiple SSDs or HDDs to a desktop with a free PCIe x1, x4, x8 or x16 slot. Hot-swap capability simplifies drive changes. Not suited for systems that lack a PCI Express slot or for users requiring hardware RAID functionality.
Marvell 88SE9215 Chipset Decides Compatibility
The onboard 88SE9215 controller determines supported SATA speeds, port multiplier modes and boot-disk capability. It complies with SATA 3.0 and PCIe 2.0 specifications. Verify that your motherboard firmware recognises this chipset for boot support.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $30.99
- Pricier than about 90% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What free PCIe slot does the Marvell 88SE9215 card need?
The card fits any PCIe 1x, 4x, 8x or 16x slot; it will not work in a legacy PCI slot.
Will my existing SATA 2.0 and 1.0 drives run at full speed on this controller?
The card is backward compatible with 3.0 Gbps and 1.5 Gbps devices, so older drives operate at their native speeds.
How can I confirm the card is booting drives in AHCI mode after install?
Enter the BIOS and verify the controller shows AHCI 1.0 mode; the OS should then detect each attached SSD or HDD as a bootable device.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Shenzhen Lianrui Information Technology SFF-8643 to SFF-8639 SATA Cable 80CM
- 80CM (2.6 ft)
- SFF-8643 to SFF-863…
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
j5create JUH377 USB 3.0 7-Port Hub 3 ft
- 3 ft (0.91 m)
- Male to Female





