Vszerda DB25 Breakout Board Solder-Free Male Adapter 25-pin data adapter
A solder-free DB25 male breakout board with labelled screw terminals, an insulated ABS case and all-copper contacts for 26-16 AWG wire up to 10 A
- Solder-free terminal block speeds up wiring
- All 25 DB25 pins clearly labelled on PCB
- Insulating ABS+PC case with anti-slip surface
- Pure copper nickel-plated contacts rated 10 A
- Accepts 26-16 AWG wires in 3 mm holes
Solder-Free DB25 Male Adapter
The Vszerda DB25 breakout board converts a 25-pin serial port to screw terminals without soldering. All signal lines are clearly labelled on the PCB. An ABS and PC insulation case with anti-slip texture encloses the board. Nickel-plated copper pins and a copper base resist oxidation.
Build Integration and Clearance
The adapter measures 59 x 55.5 x 23 mm and weighs 60 g. A 10 mm cable entry hole accepts wires from 26 to 16 AWG. Terminal holes are 3 mm in diameter on a 5 mm pitch. Each terminal accepts 0.2 N·m (1.7 lb-in) of torque for secure connections.
Suitability and Limitations
Ideal for engineers wiring industrial control gear or legacy serial equipment where soldering is impractical. The 10 A rating supports typical signal and low-power loads. Builders needing female DB25 gender, higher pin counts or sealed connectors for harsh environments should look elsewhere.
How it compares
Measured against everything we stock in Interface & Card Adapters, at today’s prices. Recalculated every night.
- Price $22.99
- Typical for this category: the median of 353 items is $21.99.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How much current can the 25-pin adapter carry continuously?
The adapter is rated for 10 A continuous current through its nickel-plated copper contacts.
How hot does the adapter get when running at full load all day?
With all-copper contact bases and an ABS-plus-PC insulating case, heat is conducted away from the terminals and the housing stays cool to the touch during sustained 10 A operation.
What wire gauges can I clamp into the screw terminals without soldering?
The terminals accept solid or stranded wire from 26 AWG up to 16 AWG, secured by the captive screws.
More in Interface & Card Adapters
Similar items
Fervit M20 Locking IP68 USB 3.1 10Gbps Type-C Female to Female Data Adapter
Silverstone ECD01 USB 2.0 to dual RS232 data adapter
- ATX Mid Tower





