Vszerda SATA 22-pin power data combo extension cable 1 foot
Combines 22-pin SATA power and data in a single one-foot extension supporting SATA III speeds up to 6Gbps
- Extends reach with 22-pin male-to-female combo
- Carries both power and data in one cable
- Supports SATA III speeds up to 6Gbps
- Works with SATA hard disks and optical drives
- 1 foot length fits tight build spaces
SATA 22-Pin Combo Extension Cable
This one-foot cable extends both data and power connections for SATA hard disks and optical drives. The female-to-male 22-pin design plugs directly between the drive and the host interface. It supports SATA III transfer rates up to 6Gbps. Builders use it when the standard cable cannot reach the drive bay.
Combined Power and Data in One Cable
The 22-pin connector merges the 7-pin data segment with the 15-pin power segment into a single housing. This reduces cable clutter compared to running separate data and power extensions. The combo design ensures both signals travel the same path, simplifying routing in tight chassis. No additional adapters or splitters are required for standard SATA devices.
Check Drive and Motherboard Connector Orientation
Verify that the drive and motherboard or controller both present standard 22-pin SATA ports before ordering. The cable adds one foot of length, so measure the routing distance inside your case to confirm the reach is sufficient. Ensure the latch orientation on both ends matches the port layout to avoid blocked adjacent slots. The cable carries only SATA signals and cannot be used with other interface types.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $8.99
- Cheaper than about 75% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Will the 22-pin connectors wear out from repeated drive swaps?
The cable uses standard 22-pin SATA connectors rated for typical insertion cycles; avoid excessive force when mating or unmating to preserve the gold-plated contacts.
Does the 1-foot length limit SATA III 6Gbps signal integrity under sustained transfers?
At one foot the cable is well within the SATA specification for 6Gbps operation, so sustained throughput is not limited by length.
Does the combo cable run warm or draw extra power when a drive is active all day?
The cable is passive copper with no active circuitry, so it adds negligible resistance and generates no measurable heat during continuous operation.
More in SATA & eSATA Drive Cables
Similar items
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
NEON Drive IEEE 1394 Firewire cable 4-pin to 9-pin 300cm 10-ft
- IEEE 1394(Firewire)
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors





