Vszerda SFF-8087 to 4 SATA Forward Breakout Cable 1.64ft
Connects an SFF-8087 controller to four SATA drives at 6Gbps each in a 1.64ft blue cable with latch locking and port markers
- Connect RAID controller to four SATA drives via SFF-8087
- Up to 6 Gbps per SATA port for fast throughput
- 64 ft length keeps internal routing tidy
- Latch-locking connectors on both ends secure the link
- Blue woven mesh sleeve protects half the cable run
SFF-8087 to 4 SATA breakout
This cable connects a RAID or PCIe controller with an SFF-8087 port to four SATA drives. It suits builders adding direct-attached storage to a server or workstation. The forward breakout design links one controller port to multiple drive targets.
Build quality and daily handling
A woven mesh sheath covers half the cable length for protected routing inside a chassis. Latch-locking connectors on both the SFF-8087 male plug and the four SATA female ports resist accidental disconnection. P1 to P4 markers identify each channel after installation. Blue cable with black sleeving aids visual tracing.
6 Gbps per SATA port
Each of the four SATA connections supports up to 6 Gbps data transfer. The link spans two PCIe 2.0 x8 lanes with compatible host bus adapters. Cable length is 1.64 feet. This part does not suit builds needing longer reach or external eSATA connections.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $10.99
- Cheaper than about 65% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What data rate does the SFF-8087 interface cap each SATA drive at?
The SFF-8087 connector supports up to 6Gbps per SATA port, matching the SATA 6Gbps specification.
What clearance does the 1.64ft cable with woven mesh sheath need inside a case?
The 1.64ft length and half-length mesh sleeve suit tight server chassis; allow room for the SFF-8087 latch and four SATA latches.
How do I install the SFF-8087 to 4 SATA breakout cable and which step is often missed?
Plug the SFF-8087 male end into the controller until the latch clicks, then attach each SATA female end to drives; verify P1–P4 markers match the array order.
More in SATA & eSATA Drive Cables
Similar items
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
iKKEGOL USB 2.0 to 2.5" 3.5" 5.25" SATA OTB Adapter
- 3 ft (0.91 m)
- 1 x eSATA to 1 x eS…





