Vszerda SFF-8482 SAS to SATA adapter cable 2.3ft
Connects a SAS drive to a SAS-capable SATA controller with integrated Molex power over 2.3 ft
- Connect SAS drives to SATA controllers
- 6 Gbps SATA III data transfer rate
- Includes 7 inch Molex power connector
- 3 ft cable length for flexible routing
- Works with both SAS and SATA drives
SAS-to-SATA adapter cable for SAS drives
This adapter cable connects a SAS drive to a motherboard SATA port that supports SAS signalling. It includes a 7-inch Molex power lead so the drive receives both data and power from a single assembly. The 2.3 ft length suits typical server or workstation chassis routing.
Requires a SAS-compatible SATA controller
The SFF-8482 connector only functions when the host controller explicitly supports SAS drives on its SATA ports. A standard SATA-only controller will not recognise the drive, so verify the motherboard or RAID card documentation before purchase.
Frees a backplane slot and uses one Molex lead
By converting the SAS device connector directly to a SATA host port, the cable removes the need for a dedicated SAS backplane or HBA bracket. It draws drive power from a single Molex 4-pin connector, leaving other power cables available for additional devices.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $7.99
- Cheaper than about 80% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Will a SAS drive run at full 6 Gbps through this adapter on a SATA III port?
The cable supports SATA III 6 Gbps data transfer, so a SAS drive will operate at up to 6 Gbps provided the controller and drive both support that speed.
Does the SFF-8482 connector require a SAS-capable SATA controller to function?
Yes, the host SATA port must be on a controller that explicitly supports SAS drives; a standard SATA-only controller will not recognise the SAS device.
How much clearance do I need for the 2.3 ft data cable and 7 inch Molex power lead?
The data cable is 2.3 ft long and the Molex power lead is 7 inches, so allow at least that much reach from the drive bay to the motherboard and power supply.
More in SATA & eSATA Drive Cables
Similar items
Micro Connectors SATA cable 40 inches straight to right angle locking latch black 3 pack
- Black
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
Micro Connectors 23" 1-to-4 15-Pin SATA Power Splitter Cable
- SATA
- Black
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Micro Connectors 0.5 m SATA III Right Angle to Right Angle Data Cable 3-Pack Red
- Red





