We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

YINGHUA

YINGHUA 5015 DC5V MK3S+ Blower Fan 3D Printers Accessory

SKU CH-JASH-DSMYY

A 5015 DC5V blower fan with dual-ball bearing replaces the extruder hot-end cooler on MK3S+ printers, drawing 0.35A through a 750mm cable

  • Efficient 5015 blower cools extruder hotend
  • DC5V 0.35A draw keeps power use low
  • Dual-ball bearing rated for 50000 hours life
  • 750mm cable reaches most printer layouts easily
  • ABS housing resists heat during long prints

YINGHUA 5015 DC5V Blower Fan for MK3S+

This 5015 blower fan is designed as a direct replacement part for the MK3S+ 3D printer extruder hotend. It runs on 5 V DC and draws 0.35 A, using a brushless motor with a sleeve bearing rated for over 50 000 hours of continuous operation. The cable measures approximately 750 mm or 29.52 inches, simplifying routing inside the printer enclosure.

Makers maintaining an MK3S+ hotend

Builders who need a 5 V radial blower that matches the original extruder mount and wiring will find this unit fits without modification. Printers that use a different voltage supply, a larger or smaller fan frame, or a connector type not matched by the supplied leads cannot use this cooler and should look for a compatible alternative.

5 V DC operating voltage

The fan is specified for 5 V DC only; applying a higher voltage will damage the motor and void the expected 50 000‑hour bearing life. Confirm that the printer’s control board provides a 5 V fan header before installation.

How it compares

Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.

Price $13.99
Cheaper than about 85% of the 590 comparable items (median $31.99).

New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How much current does the 0.35 A rating draw from a 5 V printer board?

The fan draws 0.35 A at 5 V, which is well within the typical fan-header limit on most 3D printer control boards.

What connector standard does the 750 mm cable use for the MK3S+?

The 750 mm lead terminates in the standard JST-PH 2-pin plug that fits the Prusa MK3S+ extruder fan header directly.

Will the 5015 housing clear the MK3S+ extruder shroud screws?

The 5015 frame matches the original fan footprint, so it bolts onto the existing MK3S+ shroud without modification.

More in 3D Printing Accessories & Materials

Similar items